|
Poly-Toggle Powers Anchor
|
 |
|
|
|
The Poly-Toggle is a screw actuated hollow wall anchor for use in paneling, wallboard, and solid masonry. The Poly-Toggle anchor is available in 6 sizes to match the most common wall thicknesses of hollow base materials. In solid base materials, the anchor can be used by removing the outer wings.
|
|
|
|
|
|
|
Pop-Toggle Powers Anchor
|
|
|
|
|
Pop-Toggle™ fasteners are hollow wall anchors ideal for static applications requiring light to medium load performance. Installation is very fast, needing a pre-drilled 5/16" diameter hole. The fastener pre-installs without a screw, allowing for easy placement and removal of the fixture. Pop-Toggle™ fasteners are not recommended for use overhead or applications where holding values are critical.
|
|
|
|
|
|
|
Strap-Toggle Powers Anchor
|
|
|
|
|
The Strap-Toggle™ is a pre-assembled anchor consisting of a carbon steel wing and a locking cap / ratchet leg assembly molded from engineered plastic. When compared to traditional toggles, this unique anchor can be installed through a smaller hole and does not require a fixture or screw to set it.
|
|
|
|
|
|
|
Toggle Bolt Powers Wing Type Anchor
|
|
|
|
|
The Toggle Bolt is a spring wing type hollow wall anchor designed for use in block, wallboard and other hollow base materials. The Toggle Bolt is a two-part assembly consisting of a machine screw and a spring wing toggle. Sizes range from 1/8" x 2" to 1/2" x 6" with combo round, flat, mushroom, tie-wire or slotted hex head styles.
|
|
|
|
